Net Connection (CDMA& Dial Up) & Bios Setting

CDMA NET CONNECTION SETTING
* Click on Start.
* Click on Setting
* Click on control panel
* Double click on Phone and modem
* {fill area code ( e.g......023)
* Select Modem
* Click Add
* Put tick on" Don't detect my Modem I will select it from list."
* Click on NEXT.
* Select Modem standard 33600 bps Modem
* Click on NEXT.
* Select com-1 then selected port
* Click on NEXT.
* Click on Finish
* Select standard 33600 bps Modem
* Click on Properties
* Click on Advanced
* Fill (Type =>(AT+CRM=1))
* Click on OK.
* Click on OK
* Again ;Right click on My Network Places
* Click on Properties
* Click on create new connection.
* Click on NEXT.
* Select on.'connect to the internet'.
* Click on NEXT.
* Select.'Setup my connection manually'
* Click on NEXT.
* Select.' connect using a dial-up Modem
* Click on NEXT.
* Type ISP Name=>(NTC or CDMA)
* Click on NEXT.
* Phone number = #777
* Click on NEXT.
* User name = (Eg.23696048)
* Password = (Eg.23696048)
* Confirm password = 23696048
* Click on NEXT.
* Select Add a shortcut to this Connection to my desktop.
* Click on Finish.
****************Best of Luck*************
---------------------------------------------------------------------.
CREATING DIAL UP CONNECTION OF LANDLINE

* First install the modem driver
* Right click on my network place
* Click on Properties
* Click on Create a new connection
* Click on NEXT.
* Select.' connect to the network at my work place
* Click on NEXT.
* Select.' Dial-up-connection
* Click on NEXT.
* Click on NEXT.
* Fill company name... (e.g...wlink or ntc)
* Click on NEXT.
* Phone number={ntc=15000,wlink=15100}
* Click on NEXT.
* Select Add a shortcut to this connection to my desktop.
* Click on finish.
BIOS-SETTING
* Restart computer.
* Press Del continue until it enter the bios setting
#1.Standard CMOS Feature.
* Press ENTER
* Change Time and Date.
* Change Floppy Disk.
* Change Hard disk as master and slave.
* Press ESC
* Others keep as same..........
#2.Advanced Bios Feature
* USB Flash Disk ---Auto.
* First Boot Device----CD ROM
* Second Boot Device----HDD-1
* Third Boot Device----HDD-0
* Other Boot Device----Enabled
* Security option->-------- {setup to bios...}.
{System to windows...}
* Press ESC
#3.Advanced Chipset Feature.
{There is no need of change}
# 4. Integrated Peripherals.
* On chipset primary.PCI-----Enabled
* **If disabled it don't read primary HDD
* On chipset secondary. PCI IDE-------Enabled
* USB Keyboard------Enabled
* USB Controller-----Enabled
* USB 2.0 Controller------Enabled
* AC97 Audio-------Auto
* Init Display First--------On Board{PCI Slot}
* ***If PCI is set then PCI Slot and it is also for Graphics. ***
* Press ESC
#5.Power Management Setup.
{There is also no need of change......}
#6.Load Fails – Safe Defaults
* Press ENTER
* Press Y
* Press ENTER
#7.Load Optimized Defaults
* Press ENTER
* Press y
* Press ENTER
#8.Set Supervisor Password
* Press ENTER
* Set password...........
#9.Set User Password
* Press ENTER
* Set password...........
#10.Save and Exit
#10.Save without Exit

**********BEST OF LUCK**********
----------------------------------------------------------------------